Bailey IMFEC11 - Page 55

Index - 2 WBPEEUI240756A0
Index (continued)
®
N
NIAI04
Cable connections................................................ B-2
Configuration........................................................ B-1
Dipswitch settings................................................. B-2
Input circuit........................................................... B-1
Installation .............................................................3-5
Terminal assignments.......................................... B-1
Nomenclature..............................................................1-6
NTAI05
Cable connections................................................ A-2
Configuration........................................................ A-1
Dipshunt settings.................................................. A-2
Installation .............................................................3-5
Terminal assignments.......................................... A-3
NTFB01.......................................................................4-2
Cable connections................................................ C-2
Configuration........................................................ C-1
Input circuit........................................................... C-1
Terminal assignments.......................................... C-2
O
Operating mode jumper (J1).......................................3-4
Operating mode jumper (J3).......................................3-4
Operating procedures .................................................4-1
Operation, System ......................................................2-8
Ordering parts.............................................................8-1
P
P1 edge connector pin assignments...........................5-4
P2 edge connector pin assignments...........................5-4
P3 input signal pin assignments..................................5-4
P4 pin assignments.....................................................5-5
Pin assignments, edge connector...............................5-4
Point-to-point operation.............................................. A-1
Preventive maintenance schedule ..............................6-1
Printed circuit board cleaning......................................6-3
Procedures, maintenance...........................................6-2
R
Red/green LED........................................................... 4-3
Reference documents ................................................ 1-5
Repair and replacement procedures .......................... 7-1
Replacement parts ..................................................... 8-1
Replacing a module.................................................... 7-1
S
Smart transmitter error codes..................................... 5-2
Special handling ......................................................... 3-1
Specifications ............................................................. 1-7
Start-up....................................................................... 4-1
Status LED ................................................................. 4-3
Status reports ............................................................. 5-2
STT02 smart transmitter terminal............................... 4-2
Support services......................................................... 8-1
Switch settings............................................................ 3-3
System operation........................................................ 2-8
T
Technical documentation............................................ 8-1
Termination module
Configuration ........................................................B-1
Installation............................................................. 3-5
Termination unit
Configuration ........................................................A-1
FEC.................................................................C-1
Installation............................................................. 3-5
Terms and abbreviations............................................ 1-4
Tools required for maintenance.................................. 6-2
Training....................................................................... 8-1
Transmitter, error codes ............................................. 5-2
Troubleshooting.......................................................... 5-1
U
Unpacking................................................................... 3-2