3-14
3
Leisure Home Equipment
3.1.13 Electrical operating
instructions (230v)
Ensure that the water heater is full then switch
the isolation switch on. (Usually mounted on
the bunk face adjacent to the gas control
switch.)
▲ The water temperature cannot be
selected, temperature is
automatically limited to 70
o
C. For
a faster heating up the appliance
can be simultaneously operated
with gas and electrical power.
3.1.14 General Safety Notes:
▲ In the event of leaks in the gas systems or if there is a smell of gas:
- Extinguish all naked flames
- Do not smoke
- Switch off the appliance and the gas cylinder
- Open the windows
- Do not operate any electrical switches
- Have the entire system checked by an expert
● Repair jobs are only to be carried out by an expert.
● The following would invalidate the guarantee;
a. Any alteration to the appliance (including cowl)
b. The use of non-Alde spare parts/accessories
c. Non observance of the operating instructions
● The operating pressure for the gas supply is 30mbar (or for 28mbar butane / 37 mbar propane) and
must correspond to the operating pressure of the appliance (see name plate).
● Do not operate the water heater when refuelling the vehicle and when in the garage.
● During the initial operation of a brand new appliance (or after it has not been used for some time), a
certain amount of fumes and a slight smell may be noticed for a short time. Remedial action here is
to immediately run the heater at maximum output and to ensure adequate room ventilation.
● If the burner makes an unusual noise or if the flame lifts off, it is likely that the regulator is faulty and
it is essential to have it checked.
To Next Page
Loading...