3-33
Leisure Home Equipment
3
3.10.2 Preparing for use (standard)
● Open the access door on the outside of your Leisure Home.
● Remove the Waste Holding Tank by pulling the safety catch (which holds the tank in place) upwards.
● Pull the Waste Holding Tank outward to the stop. Tip it slightly and take the tank fully out.
● Place the tank upright and turn the rotating emptying spout upwards. The emptying spout ensures
that the tank can be easily and hygienically emptied.
● Remove the cap, with the measuring cup inside, from the emptying spout and pour the correct
dosage of Thetford toilet fluid (see product label) into the holding tank. This avoids unpleasant
smells and keeps the inside of the tank clean. Next add approximately 2 litres of water - enough to
ensure that the bottom of the Waste Holding Tank is covered. Screw the cap back onto the emptying
spout and turn back to its original position.
▲ The Emptying Spout Measuring Cap is supplied inside the toilet.
▲ Never add toilet fluid directly via the blade or the toilet bowl as this could damage the lip
seal of the Waste Holding Tank. Always pour the fluids via the emptying spout. The lip
seal is the water tight seal around the top of the tank.
To Next Page
Loading...
