Baldor MotiFlex e100 - A.1.1 Busbars for DC Bus Sharing

www.baldormotion.com
A-2 Accessories MN1943
A.1.1 Busbars for DC bus sharing
Plated copper busbars are required to allow the DC bus voltage to be shared between
neighboring MotiFlex e100 drives. The busbars are made from tin plated copper, and are
available in four different sizes. The required size depends upon the combination of drive types
and their relative positions. See Figure 6 on page 3-9 to determine which busbars are required.
55 mm
Siz e 1 busbar - kit OPT-MF-DC-A
Siz e 2 busbar - kit OPT-MF-DC-B
107 mm
Siz e 3 busbar - kit OPT-MF-DC-C
140.4 mm
Siz e 4 busbar - kit OPT-MF-DC-D
192 mm
Figure 95 - Using busbars for DC bus sharing