Baldor MotiFlex e100 - Basic Installation; Mechanical Installation

Contents i
MN1943
Contents
1 General Information 1 -1.................................
2 Introduction 2-1........................................
2.1 MotiFlex e100 features 2-1..................................
2.2 Receiving and inspection 2-2................................
2.2.1 Identifying the catalog number 2-2....................................
2.3 Units and abbreviations 2-3..................................
2.4 Standards 2-4..............................................
2.4.1 Design and test standards 2-4.......................................
2.4.2 Environmental test standards: 2-4....................................
2.4.3 Marks 2-4........................................................
3 Basic In stallation 3-1....................................
3.1 Introduction 3-1............................................
3.1.1 Power sources 3-1................................................
3.1.2 Hardware requirements 3-1.........................................
3.1.3 Tools and miscellaneous hardware 3-2................................
3.1.4 Other information needed for installation 3-2...........................
3.2 Mechanical installation 3-3...................................
3.2.1 Dimensions - 1.5 A ~ 16 A models 3-4................................
3.2.2 Dimensions - 21 A ~ 33.5 A models 3-5...............................
3.2.3 Dimensions - 48 A ~ 65 A models 3-6.................................
3.2.4 Mounting the MotiFlex e100 3-7......................................
3.2.5 Overtemperature trips and intelligent fan control 3-10.....................
3.3 Connector locations 3-11.....................................
3.3.1 Front panel connectors 3-11..........................................
3.3.2 Top panel connectors 3-12...........................................
3.3.3 Bottom panel connectors 3-13........................................
3.4 AC power connections 3-14...................................
3.4.1 Earthing / grounding 3-14............................................
3.4.2 AC input and regeneration resistor output wiring 3-15.....................
3.4.3 Earth leakage 3-16.................................................
3.4.4 AC power connections 3-17..........................................
3.4.5 AC power cycling 3-18..............................................
3.4.6 Inrush current 3-18.................................................
3.4.7 Phase loss detection 3-18............................................
3.4.8 Drive overload protection 3-18........................................
3.4.9 Input power conditioning 3-19.........................................
3.4.10 Power supply filters 3-20.............................................
3.4.11 Power disconnect and protection devices 3-21..........................
3.4.12 Recommended wire sizes 3-22.......................................