5
Programming
14
BVS HS-PB
Industrial Cordless Handheld Barcode Reader
5 Programming
The reader is factory-configured with a set of standard default features.
Customize your reader through use of the programming barcodes
available in the BVS HS-PB series. Check the corresponding features
section for your interface, and also the Data Editing and Symbologies
chapters of the OPM.
5.1 Using Programming Barcodes
This manual contains barcodes which allow you to reconfigure your
reader. Some programming barcode labels, like the , require only the
scan of that single label to enact the change.
Other barcodes require the reader to be placed in Programming Mode
prior to scanning them. Scan an ENTER/EXIT barcode once to enter
Programming Mode; scan the desired parameter settings; scan the
ENTER/EXIT barcode again to accept your changes, which exits Pro-
gramming Mode and returns the reader to normal operation.
5.2 Configure Other Settings
Additional programming barcodes are available in the OPM to allow for
customizing programming features. If your installation requires different
programming than the standard factory default settings, refer to the
OPM.
5.3 Resetting Product Defaults
If you aren’t sure what programming options are in your reader, or
you’ve changed some options and want your custom factory settings
restored, scan the barcode below to reset the reader to initial configu-
ration. See the OPM for other options, and a listing of standard factory
settings.
NOTE
Factory defaults are based on the interface type.
Be sure your reader is configured for the correct
interface before scanning this label.
To Next Page
Loading...