12
Reading Parameters
26
BVS HS-PB
Industrial Cordless Handheld Barcode Reader
12 Reading Parameters
Move the reader toward the target and center the aiming pattern and
illumination system to capture and decode the image. See "Using the
Balluff BVS HS-PB reader" on page 9 for more information.
The aiming system will briefly switch off after the acquisition time, and if
no code is decoded will switch on again before the next acquisition.
The illuminator will remain on until the symbol is decoded.
As you read code symbols, adjust the distance at which you are hold-
ing the reader.
12.1 Good Read Green Spot Duration
Successful reading can be signaled by a good read green spot. Use
the barcodes that follow to specify the duration of the good read
pointer beam after a good read.
ENTER/EXIT PROGRAMMING MODE
Disabled
Short (300 ms)
Medium (500 ms)
Long (800 ms)
To Next Page
Loading...