102
Figure 11: Stop recording
When recording to an output file which has the same file name as the previous one while overwriting the recorded
content is not desired:
1. When clicking 'Start', a file selector will pop up to ask users to create a new output file with the same file type
as the previous one. If a new set of parameters of the video stream recording is needed, please click 'Cancel'
in the file selector and re-configure parameters in the setup dialog.
Figure 12: Select a new file when starting to record to an output file with the same file name as the previous
one without overwriting
2. Once a new file has been created, the video stream will start to get recorded. The current recording status
and information will be displayed in the analysis output. During recording, the setup dialog as well as the
'Start' button will be disabled. The 'Pause' and 'Stop' buttons will then be enabled.
MATRIX VISION GmbH
To Next Page
Loading...
Need help?
General
