searching
resonance frequency
calibration
searching
resonance frequency
scanning 30496 Hz
serching
resonance frequency
fine tuning 29910 Hz
29 / 3851406c GB/2019-07
1 electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • info@bandelin.com
The frequency scan is completed once fi ne-tuning has been successful, and the display switches
back to stand-by mode.
Otherwise, an error message such as Error 012 appears again.
IMPORTANT
Only allow repairs to be conducted by authorised skilled personnel !
Kindly inform us in writing of any malfunctions – use the enclosed questionnaire.
Important information
• Before each repair, turn off the device and disconnect the plug from the mains!
• Defective parts may only be replaced with original parts.
The black housing of the ultrasonic transducer (ultrasonic oscillating system) may not be turned
against each other. The ultrasonic oscillating system and its electrical connections would be
damaged as a result.
To Next Page
Loading...
