Bandit
10
Copyright 4/21
MODELS 2550/2550T
SAFETY PROCEDURES
Check laws and regulations. Know and obey all
federal, state, and local laws and regulations that
apply to your work situation and the transportation
of a machine this size.
WARNING
!
CLEAN MACHINE OF ALL DEBRIS!
DO NOT
leave this machine unattended until all potential re
debris is removed, no re or smoldering exists, and
hot spots are cold. The engine creates many hot
spots including: exhaust manifold, exhaust, turbo (if
equipped), etc. Remove all ammable debris such
as wood, chips, leaves, oils, fuels, etc. from engine
exhaust, engine turbo (if equipped), beside, around,
and under engine, around and under tanks, inside
belt shields and guards, inside battery and tool
boxes, inside cabinets (if equipped), and anywhere
materials collect. ALWAYS keep several type A:B:C re
extinguishers operational and on the job at all times.
WARNING
!
WARNING
!
Sparks can occur if cutter teeth strike rocks,
metal, or other hard objects.
DO NOT use in high or very high re hazard
severity zones.
Operation of this equipment may create sparks
that can start res around dry vegetation. A spark
arrester may be required. The operator should
contact local re agencies for laws or regulations
relating to re prevention requirements.
Do Not continue to operate the machine if the
cutter wheel stalls. Immediately lift cutter wheel out
of the stump, dirt, etc. and start again with less bite.
Prolonged cutter wheel stall will ruin the hydraulic
components or belts, creating extreme heat and
possible re hazard.
WARNING
!
Before performing maintenance on the machine
remove all debris, oil, grease, water, snow, ice, etc.
from all machine surfaces.
WARNING
!
DANGER
!
Keep hands clear of all pinch points.
DANGER
!
Do not touch hot machine surfaces. The machine
surfaces may be hot due to the machine operating
recently or the machine setting in the sunlight.
WARNING
!
Unless going through a narrow passageway or
gate, always keep the dual tires installed or the tracks
expanded for machine stability.
To Next Page
Loading...
