Bandit 2550 - Page 50

Bandit
46
Copyright 4/21
MODELS 2550/2550T
CHECK
# DESCRIPTION DAY WEEK MONTH PROCEDURE
1 Cutter Wheel Arm Pivot Bushings X 1 - 2 shots of grease - wipe o󰀨 excess
2 Swing Pivot Ass’y Bushings X 1 - 2 shots of grease - wipe o󰀨 excess
3 Cylinder Lug Pin Bushings X 1 - 2 shots of grease - wipe o󰀨 excess
4 Swing Out Pivot Bushings X 1 - 2 shots of grease - wipe o󰀨 excess
5
Steel Friction Areas: pivoting,
hinged, sliding, rolling
X
Lubricate (i.e. cutter wheel guard, control
box doors, etc.)
6 Grading Blade Pivot Bushings X 1 - 2 shots of grease - wipe o󰀨 excess
7 Cutter Wheel Engagement Cable X Lubricate cable ends with SAE 10W/30
LUBRICATION CHART - 2550T
Use as a reference only, locations may vary depending on options or component manufacturer.
Lubrication point instructions are described on the machine, in the Lubrication & Coolant
Section and Maintenance Section of this manual, or component manufacturer’s manual.
NOTICE
MAINTENANCE
2
3
5
3
2
1
3