Bandit
48
Copyright 4/21
MODELS 2550/2550T
WINDOW WASHING INSTRUCTIONS
DO NOT use any glass cleaner on windows. Follow these steps to clean the windows:
DO NOT USE RAZOR BLADES, SCRAPERS, SQUEEGEES, ETC.
1. Rinse with water to remove abrasive dust and dirt.
2. Wash with soap or mild detergent, using a soft cloth or sponge.
Compatible cleaners: Top Job, Joy®, Palmolive Liquid®, Windex® Ammonia Free
DO NOT SCRUB
3. Rinse once more, then dry with a soft cloth or chamois.
4.
To remove grease, wet paint or decals: rub gently with a cloth wetted thoroughly in VM&P Natha or
Isopropyl Alcohol. Wash and rinse.
PAINT CARE & WINDOW WASHING
To help keep up the appearance of your Bandit equipment and reduce the possibility of surface rust follow
these steps:
1. The machine should be washed by hand with water for the rst 30 days when the paint is fresh. Afterwards,
the machine should be washed on a regular basis
with an automotive wash soap (not degreaser) and
then rinsed thoroughly.
Do not pressure wash sensitive areas
like: decals, gauges, electronic devices, near chips in the paint,
etc. If a pressure washer is used after the rst 3 months after painting, be aware they are capable of
extreme pressures and can damage paint nishes. Also, only use 1500 to 2000 psi with a round pattern
nozzle (not a pin point or knife style nozzle) and hold the gun/wand a minimum of 24” (0.6 m) away from
the machine.
Always wash the machine immediately upon delivery, when the machine is new.
4. If shipping or towing the machine in conditions that include road salt/brine, any other ice melt or dust
control products,
always wash the machine immediately upon arrival or at the end of the work day.
5.
Park the machine inside or under a roof when not in use.
6. Do not allow fuel, antifreeze, DEF uid, or any other motor uid to set on the machine. Remove immediately.
7. If a stone chip, paint scratch, or paint crack occurs - it should be repaired immediately. Simply sand the
edges of the damaged paint area, mask o the surrounding area, and apply primer and paint to the dry,
clean, and warm area. This will keep the damaged area from spreading or getting worse.
8. If you are unable to sand and mask the area, there are containers of primer and paint available. A small
brush can be used to touch up the area after it is cleaned, dry, and warmed. Also, primer and most colors
of paint are available in aerosol spray cans.
Keep good mud aps on towing trucks to reduce stone chips.
Use an automotive wax on a regular basis after the rst 3 months after painting.
PAINT CARE
MAINTENANCE
To Next Page
Loading...
