Bandit
54
Copyright 4/21
MODELS 2550/2550T
TROUBLESHOOTING
MAINTENANCE
PROBLEM POSSIBLE CAUSE SOLUTION
Engine will
not start. (See
Engine Mfg.
manual for further
information).
Loose ground cable. Clean and tighten.
Loose hot cable. Clean and tighten.
Dead battery. Recharge or replace.
Cutter wheel was engaged before the
machine was started.
Make sure the ignition switch is o,
disengage cutter wheel, and then
restart the machine.
Batteries in remote are dead. Replace.
Emergency stop activated.
Pull or twist the emergency stop to
deactivate.
Cutter wheel
vibration.
Tooth missing. Replace missing teeth.
Pocket out of balance.
Do not mix new and worn teeth.
Always replace pockets in pairs across
from each other.
Improper tooth arrangement.
Do not mix new and worn teeth.
Install correctly with like pairs of teeth
directly across from each other.
Cutter wheel
throwing teeth.
Bad pocket. Replace pocket.
Dirt in pocket.
Clean pocket and replace teeth.
Always replace pockets in pairs
across from each other.
Breaking teeth. Operator hitting rocks. Avoid rocks, stones, etc.
Cutter wheel stops
turning.
Bad hydrostatic motor. Replace.
Bad hydrostatic pump. Replace.
Engagement cable loose or broke. Adjust or replace.
Low hydraulic pressure. Reset pressure.
Debris wedged around cutter wheel. Clean out debris.
Bearing will not
take grease.
Grease tting clogged. Replace.
Machine will not
respond to remote.
Weak or dead batteries. Replace
Remote not turned on before starting
the machine engine.
Turn o engine, turn remote power on
and then restart the machine.
Machine is out of range of the remote.
Move closer and make sure there are
not obstructions between the operator
and the machine.
Broken or damaged antenna. Replace.
Remote power switch is turned o. Shut down and restart the machine.
To Next Page
Loading...
