Bandit
63
Copyright 4/21
MODELS 2550/2550T HYDRAULICS
HYDRAULIC SYSTEM TROUBLESHOOTING (cont.)
(BRAKES WILL NOT HOLD)
FITTING
1. Follow all pre-maintenance shut down procedures.
2. Remove and clean the tting shown in above picture.
3. Reassemble the tting as shown above.
4. If this does not solve the problem contact your local dealer or Bandit Industries, Inc.
After the initial start-up of the machine and after any replacement of hydraulic components, that ttings
and hoses should be re-checked for leaks and clearances.
Before attempting any type of maintenance disengage clutch, turn o engine, wait for the cutter wheel to
come to a complete stop, install the cutter wheel lock pin, place the cutter wheel on the ground, disconnect
battery, and make sure the ignition key is in your possession.
DO NOT operate this machine unless all hydraulic control devices operate properly. They must function,
shift and position smoothly and accurately at all times. Faulty controls can cause personal injury!
It is very important after you have operated a new machine for approximately an hour to shut down the machine
and recheck all hydraulic ttings. Retighten as needed.
DO NOT GO NEAR HYDRAULIC LEAKS! High pressure oil easily punctures skin causing serious injury, gangrene,
or death. Avoid burns from uid. Hot uid under pressure can cause severe burns. DO NOT use ngers or skin to
check for leaks. Lower load or relieve hydraulic pressure before loosening ttings. Relieve all pressure in the system
before disconnecting the lines, hoses, or performing other work. Use a piece of cardboard to nd leaks. Never use
your bare hands. Allow system to cool down to ambient temperature before opening any coolant or hydraulic oil
system.
In cold weather situations let your hydraulic system idle for approximately 15 minutes to allow the system to warm
up to operating temperature.
DANGER
!
WARNING
!
WARNING
!
CAUTION
!
To Next Page
Loading...
