Bandit 75 - Scheduled Maintenance Intervals; Weekly, Monthly, and Quarterly Tasks; 3 Month and Yearly Maintenance Tasks

Bandit27
MODEL 75 MAINTENANCE
WEEKLY MAINTENANCE
WHEEL LUG NUTS
STEEL FRICTION AREAS
CHAIN DRIVEN COMPONENTS
Keep lug nuts tight, retorque, replace if needed.
Lubricate all steel friction areas including, but not
limited to pivoting, hinged, sliding, rotating areas on
the machine (i.e. stop bar, folding tray, discharge
ipper, hydraulic valves & linkages, height adjustable
discharge, discharge T-handle, etc.)
Use a dry lube on any chain driven components:
hydraulic swivel discharge and chain driven
feedwheels.
ALTERNATOR & FAN BELTS ON ENGINE
Inspect belt condition and replace as needed.
As applicable adjust and maintain per the engine
manufacturer’s manual.
MONTHLY MAINTENANCE
CHIPPER BEARINGS & CHIPPER SHEAVE
HYDRAULIC FUNCTION PRESSURES
WHEEL BEARINGS
BRAKES
DISCHARGE CHAIN TENSION
TOWING HITCH
DISCHARGE & INFEED HOPPER WEAR
SHARPNESS OF FEEDWHEEL TEETH
Check, retighten all bearing bolts, bearing lock
collars, and also belt sheave bushings to correct
torques.
Check, reset and maintain all hydraulic function
pressure settings to a maximum of the specied
pressure. This will give you the best performance
from the hydraulic system.
Check and grease or oil wheel bearings per axle
manufacturer’s instructions.
Check and adjust brakes as needed per axle MFG.
manual.
Check tension on hand crank swivel discharge
chain drive and tighten as necessary. Chain tension
is 1/4” (6 mm) per foot (0.3 m) of center distance
between sprockets, NOT to exceed a 1/2” (13 mm)
of deection. Do not overtighten.
Check for excessive damage or wear. Replace if
needed. Keep pintle ring greased to reduce wear.
Check for wear on discharge, infeed hopper,
and discharge direction adjuster; build up, repair or
replace as needed.
Replace if needed.
3 MONTH
MAINTENANCE
YEARLY
MAINTENANCE
HYDRAULIC OIL FILTER(S) HYDRAULIC OIL
HYDRAULIC SUCTION SCREEN(S)
FUEL TANK
Must be replaced after rst 10 hours of operation,
use a 10 micron lter. After rst change replace oil
lter every 3 months or 400 hours.
Change hydraulic oil and flush the hydraulic
reservoir tank.
Change hydraulic suction screen(s) yearly or
every 2000 hours.
Drain and clean the fuel tank yearly.
DISCHARGE SWIVEL PLATES
Grease swivel plates for discharge as needed.