Bandit33
MODEL 75 MAINTENANCE
CHIPPER DISC
Check chipper disc assembly for excessive wear,
elongated knife bolt holes, secure welds, and impact
cracks. If a problem is found, contact your nearest
dealer or Bandit Industries, Inc.
NOTICE
Do not under any circumstance attempt to rotate
the chipper disc while someone is inside the infeed
hopper. This will cause serious injury.
DANGER
DANGER
Chipper knives are sharp and can be dangerous.
It is always necessary for your protection to be
extra careful and wear proper hand protection when
handling knives.
Elongated
Bolt Holes
Cracks /
Excessive Wear
Secure Welds
Secure Welds
Before attempting any type of maintenance,
disengage clutch, wait for the disc to come to a complete
stop, turn o engine, remove the ignition key, make
sure the ignition key is in your possession, install the
disc lock pin, and disconnect the battery.
SAFETY INSTRUCTIONS
Make sure to check both knife pockets.
To Next Page
Loading...
