Even though it is a seven character by two-line display, channel memories are only
configurable to six character names.
Battery Level Indicator
When the battery level indicator reads the battery is depleted. At this point the radio will start
beeping periodically as well as flash the backlight of the display and when voice prompts are
enabled, a "Low Voltage" announcement will be heard, indicating that you need to change your
battery or put your radio in the charger.
Status LED
The status LED has a very simple and traditional design. When you receive a signal it turns
green, when you transmit it turns red, and it's off in standby.
Side key 1 - CALL (Broadcast FM and Alarm)
Press momentarily to start the broadcast FM receiver. Another momentary press turns
the broadcast FM receiver off. If a signal is received on the active frequency or channel while
you are listening to the broadcast FM, the receiver will open squelch to that frequency (as if
scanning) and remain there until the signal goes away; it will then switch back to broadcast FM.
Press and hold to activate the alarm function. Press (a short press) again to turn it off.
To Next Page
Loading...