Ex: Programming a Channel Repeater Offset with
CTCSS Tone
EXAMPLE New memory in Channel 99:
RX = 145.000 MHz
TX = 145.600 MHz (This is a (+ .600) Offset)
TX CTCSS tone 123.0
1. Change from Menu to Menu by pressing the [EXIT/AB] button.
2. Set radio to VFO Mode by pressing [V/M]
Channel number at the right will disappear.
3. Menu 28 [M] 9 9 [M] [EXIT] Deletes Prior Data in channel (Ex. 99)
4. Menu 13 [M] 123.0 [M] [EXIT] Selects desired TX encode tone
5. Enter RX frequency (Ex. 145000)
6. Menu 25 [M] 9 9 [M] Enter the desired channel (Ex 99)
Ø [EXIT] RX has been added
7. Enter TX frequency (Ex. 145600)
8. Menu 25 [M] 9 9 Enter the same channel (Ex 99)
Ø [EXIT] TX has been added
9. [V/M] Return to MR Mode. Channel number will re-appear.
To Next Page
Loading...