R5900100 /02 C-10, C-536
3.1 Activating the Base Unit
About power mode
The Base Unit is powered via an external power adapter. Once connected, the Base Unit is automatically
switched in standby mode. For more information about power connection, see C-10, C-5's installation manual.
Standby button
1. Push the button shortly.
Image 3–1
When the Base Unit was on, it goes to standby.
When the Base Unit was in standby, it starts up.
3.2 Basic Use, with ClickShare desktop app
About the ClickShare desktop app
With the ClickShare desktop app installed on your computer you can enter a meeting room and get on the
screen in a few seconds.
The ClickShare desktop app connects to the meeting room screen in order to share your content. Presence
detection technology is used to do so. The ClickShare desktop app uses Wi-Fi beacons and an inaudible
audio signal to detect the most nearby meeting rooms and show a list of maximum 5 most nearby meeting
rooms, sorted based on signal strength on your computer. Just click on your meeting room name. This means
you will never have to enter IP addresses or scroll long lists of meeting rooms before being connected to your
meeting room.
The ClickShare desktop app can be used with or without a Button.
ClickShare desktop app installation
When the ClickShare desktop app is not pre-deployed in your IT environment, you can download and install
the software without administrator rights from www.clickshare.app .
How to use
1. Enter a meeting room.
The ClickShare desktop app will list up to 5 most nearby meeting rooms and sort them based on the signal
strength.
Getting started
To Next Page
Loading...
Need help?
General
