Barco C-10 User Manual

R5900100 /02 C-10, C-554
4.1 Basic troubleshooting
Problem solving
In this chapter some problems that might occur while using C-10, C-5 are listed. For each problem possible
causes are given and a solution is proposed. If you cannot solve the problem yourself, please contact your
local IT administrator.
Generic issues
Problem Cause Solution
Your screen is not shown on the
display when pressing the Button.
Wrong input is selected on the
display.
Select the correct input on the
display or on the room control
system
Base Unit in standby Briefly push the standby button on
the Base Unit or plug in a Button
and run the ClickShare client
software.
You are the second person that
wants to share the content to the
display.
The first user has to push his
Button to remove his content so
that a third user can share his
content. or
As second user, click and hold the
Button to use the Show me
function of ClickShare.
The ClickShare client software is
not running.
Go to the ClickShare drive and run
the software.
Your screen is shown, but your
audio is not playing on the meeting
room audio system
Your audio signal on your PC is
muted
Right click on the speaker icon
and switch off the mute.
Audio system of the meeting room
is not switched on
Switch on the audio system of the
meeting room.
When using separate audio, audio
cable is not connected
Check audio connection between
the Base Unit (audio out, green
connector) and the audio system
of the meeting room.
Default speaker is not correctly set
.
With a Button inserted, set
ClickShare speaker as your
default speaker.
Button is not re-paired after
changing the audio setting on the
web interface
Re-pair the Button.
Audio setting on the web interface
is not correctly set.
Consult your administrator to
select the correct audio setting.
Your content is removed from the
display and the LEDs of your
Button are blinking white.
Connection to the Base Unit has
been lost.
ClickShare tries to restore the
connection automatically. If this
fails, the LEDs of the Button start
blinking red. You should unplug
the Button from your laptop and
start a new.
Nothing is shown on the display at
all.
The display is switched off. Switch on the display.
Wrong input is selected. Select the correct input.
The display cable is not connected
(correctly).
(Re)insert the display cable to the
display and the Base Unit.
Troubleshooting

Barco C-10 Specifications

General

Brand	Barco
Model	C-10
Category	Projector
Language	English