2. Getting to know the projector.
When rep lacing batteries, t he b road cast address of the RCU will be reset to its default value ’0’.
CAUTION: Replace w ith the correct battery type. Use two AA size batteries. There is a risk of explosion if the
battery is replaced w ith an incorrect type.
CAUTION: Rep lace the b attery as exp lained above. T here is a risk of exp losion if the battery is incorrectly
installed.
2.7.2 Remote control, protocol setup
About the used protocol
The protocol is the co de s end out by the re mote control when a button is pressed. Depen ding on this code, the projector can dec ode
the signals. The remote control can be used with two different protocols, RC5 and NEC. Depending on the projector to c ontrol the
remote control can be sw itched between these protocols.
Which protocol to use
•TheNEC protocol have to be used for Barco projectors based on the Pulse platform: Loki, Balder, F70, F80, F90, HDX 4K,
UDX, ...
•TheRC5 protocol have to be use all other B arco projectors: HDX W, HDF W, HD
Q2K,...
How to set
1. Remove the cover. For more info on how to remove, see "Remote control, B attery installation", page 18.
2. Place t he s witch in the NEC position.
Image 2-7
Remark with RC5 protocol
Not all buttons of the Puls e RCU are o ne-to-one c ompatible with the legacy Barco R CU. Button pairs SHUTT ER open/close and
POWER on/off emit the same code (per pair) when in RC5 mode, bec ause the legacy RC U’s only had 1 button for Shutter and 1
button for Standby.
601–426 F70 SERIES 24/10/2017
19
To Next Page
Loading...
