Barco F90 - W13WUXGA - Power Mode Transitions; General; Power on Projector; Going from READY to on

5. Getting started
5.4 P ower mode transitions
5.4.1 General
Transition Diagram
This diagram shows all modes available o n the projector (un plug, O N, REA DY, EC O), and the actions necessary to chang e m ode.
2
ECO
READY
ON
1%
50%
50%
Image 5-1
-
Projector mains powered
-
Auto transition after x m inutes if ECO mode enables
-
Press power On/Off button, remote On/Off button
5.4.2 Power on projector
If not already connected, connect the female side of the power cord w ith the power input socket of the projec-
tor. For more details see section de
dicated to the power cord installation.
The background image of the st artup screen and info screens can be chang ed w ith Pro jector Toolset wi th an
installed F70 / F90 series p lug-in.
Description
Plug the 3-prong plug of power cord into a grounded AC o utlet. The projector will go to READY m ode. During this stage the system
boots and performs the internal check of the boards. The P ower O n/O ff button will B LIN KI NG WHITE until READY mode is achieved.
Once in R EADY mode, the Power On/Off button w ill be lit WH ITE .
5.4.3 Going from READY to ON
Description
Press the Po wer O n/Off button on the projector, or the Power On button on the rem ote control. The projector will power ON.The
Power O n/Off button will BLINK BLUE during the transition from READY to ON. Once the projector is on, the Power On/Off button
will be lit BLUE.
601–426 F70 SERIES 24/10/2017
45