To Next Page
J
Jennifer SanchezAug 1, 2025
What to do if Barco Projector shows wrong lamp parameters?
- KKathryn NolanAug 1, 2025
If your Barco Projector indicates wrong lamp parameters, here are a few things you can check: 1. Ensure you're using a compatible lamp house for your projector model. Note that a 3.5 kW lamp is unsuitable for FLM R20+ or FLM HD14 models. 2. Inspect the blue socket of the lamp house for any damage. If damaged, replace the lamp house and return the damaged one to the factory. 3. Examine the blue socket in the upper left corner of the lamp compartment for damage. 4. Check the wiring at the back of the blue socket inside the projector, accessible after removing the left side cover. 5. Verify that the wire unit from the blue socket in the lamp compartment is correctly plugged into its socket on the backplane behind the input & communication unit.
General
