17. Heat exchanger
17.1 Removing the defective heat exchanger
Necessary tools
•2,5mmAllenkey.
• 7 mm wrench.
• Universal plier.
How to remove the heat exchanger?
1. Uncouple the cooling circuit from the heat exchanger and from the engine (to exclude the engine cooling circuit from the complete
circuit). Press on the connector tab (1) and pull out the male valved fitting (2).
Tip: Sometimes a little cooling liquid will be spilled. Wrap a small cloth around the valved fitting while uncoupling to absorb
the spilled cooling liquid.
2
1
2
1
Image 17-2
2. Loosen both indicated screws.
Image 17-3
3. Cut the necessary cable tie(s).
4. Disconnect the heat exchanger fan and the connector in the near of the flow switch.
180
R59770072 FLM SERIES 19/03/2007
To Next Page
Loading...
Need help?
General
