11. 3D
Image 11-3
4. Put on the 3D goggles, and verify by looking through the g oggles with one eye a t the time that only one image is visible in each
eye. A double picture or a shade of the picture from the other side shall not be observed. Repeat for both sides, and adjust the
Sync Delay slider until a “clean” picture is visible in each ey e.
If the 3D picture looks a bit “strange” through the 3D goggles, the solution is to swap eyes by enabling the Swap ey es button in
the menu.
90
601–426 F70 SERIES 24/10/2017
To Next Page
Loading...
