Display Controller 23
started. If your CD/DVD drive’s auto-run is not enabled or the Barco
Product Installation Wizard does not start automatically, you can
run the Barco Product Installation Wizard manually by following
these steps:
a Click the Start button in the task bar.
b Click Run.
c Click Browse and browse to the root directory of the B
ARCO
Display System Installation CD-ROM and click on the file,
Setup.exe, and click Open.
d Click OK.
or
a Browse to the root directory of the B
ARCO Display System
Installation CD-ROM and double click on the file, Setup.exe.
3 Click Next twice.
4 Click Yes to accept the terms of the MediCal QAWeb Agent license
agreement. The Barco setup wizard will continue with the
installation only if you accept the terms of the license agreement.
If you click No, the wizard will exit. Click Next.
5 Follow the wizard’s on-screen instructions to complete the MediCal
QAWeb installation.
6 The Barco Product Installation Wizard will now guide you through
the installation of the driver.
7 Click Yes to accept the terms of the Barco and ATI license
agreements. The Barco setup wizard will continue with the
installation only if you accept the terms of both license
agreements. If you click No, the wizard will exit. Click Next.
To Next Page
Loading...
