28 Display Controller
Installing the BARCOMED CORONIS or Nio
drivers and software
The installation dialog will display in English if your operating system’s
language is not supported.
This process applies to the following versions of Windows:
• Windows XP Professional
• Windows XP Professional x64 Edition
• Windows Server 2003
• Windows Server 2003 x64 Edition
You will need to install the Barco Display System drivers and software in
the following cases:
• After you have installed the display controller(s) for your Barco
Display System in your system for the first time.
• After you have reinstalled or upgraded your operating system.
• After you have moved the display controller(s) to a different PCI/
PCIe slot.
The following will guide you through the installation procedure:
1 Start your system. When the Found New Hardware Wizard comes
up, click Cancel. When the System Settings Change window asks
you to restart your computer, click No or Restart Later.
2 Run the Barco Product Installation Wizard.
The Barco Product Installation Wizard should start automatically if
you insert the Barco Display System Installation CD-ROM into your
CD/DVD drive after the operating system has started. If your CD/
DVD drive’s auto-run is not enabled or the Barco Product
Installation Wizard does not start automatically, you can run the
Barco Product Installation Wizard manually by following these
steps:
To Next Page
Loading...
