Display Controller 27
When performing an MXRT driver upgrade, it is essential
to uninstall the previous installation before installing the
new driver. We also recommend that you perfrom the
following steps to completely remove the previously
installed files:
1 Boot the system in safe mode.
2 Run MXRT driver cleaner.bat by double clicking on it
(this will either be installed as an icon on your
desktop, or can be found on the Barco Display
System installation CD at: drivers\2KXP\ATI). This
will remove all the previous installed MXRT driver
files.
3 Reboot the system in regular mode and install the
new driver.
To Next Page
Loading...
