Display Controller 29
a Click the Start button in the task bar.
b Click Run.
c Click Browse and browse to the root directory of the B
ARCO
Display System Installation CD-ROM and click on the file,
Setup.exe, and click Open.
d Click OK.
or
a Browse to the root directory of the Barco Display System
Installation CD-ROM and double click on the file, Setup.exe.
3 Click Next twice.
4 Follow the wizard’s on-screen instructions to complete the
installation.
When the page shown below appears you may either click Next to
accept the default settings or if you know the settings required for
your viewing application, you may select them now and then click
Next. You may change these settings later by accessing the Barco
Driver tab within the Windows Display Control Panel.
Please refer to your application manuals for information on the
correct Palette and Drawing modes to select.
To Next Page
Loading...
