36 Display Controller
attach the second display you detached in step 2 above, by right
clicking on the rectangle that represents it and selecting Attached.
Now repeat steps 4-7 above for this display.
If you are using a Quad-Head Configuration repeat all of the above
steps for the two displays on the second display controller.
Setting the Color and Palette Modes
(See “Control Panel Settings” on page 37)
Configuring the Windows desktop
If you are using a color display in conjunction with your Barco grayscale
display(s) you should configure your desktop before setting the
resolution of the your Barco grayscale display(s).
If you have a single display configuration and you have
enabled DualView, Windows will not allow you to attach
the second head. This is normal and not a bug.
After enabling DualView and setting the resolutions in a
Quad-Head Configuration you may need to drag the
heads into the proper position in the window on the
“Settings” tab, so that the arrangement in the window on
the “Settings” tab matches the physical arrangement of
your configuration.
In order to configure the Windows Desktop of your BarcoMed
Display System you must be logged in using an account with
administrator privileges.
To Next Page
Loading...
