Display Controller 41
• SingleView
A single large desktop spans across both displays.
• Clone
The primary display is cloned to the secondary display.
COLOR FORMAT:
• 24-Bit TrueColor Mode
• 30-Bit TrueColor Mode (HDR)
DISPLAY RESOLUTION:
• Sets display resolution for 1 or 2 displays.
To switch out of SingleView or Clone mode, the buttons in this
Control Panel page must be used. The main Windows Control Panel
cannot be used. Depending on your system, certain configurations
can be disabled.
Clone mode is supported for two color displays or projectors in
32bpp. Clone mode is not supported on grayscale displays. Also,
30-bit desktop is not supported while in Clone Mode.
When choosing Clone Mode under the Barco Adapter Configuration
page, if two displays are enabled, then the larger of the two
current resolutions will be used. If only one of the two displays is
enabled, the enabled displayís current resolution will be used.
When the resolution set for clone mode is larger then the
maximum supported on a display, the resolution set on the Master
will automatically be scaled to maximum resolution of the Cloned
display. If the Scale to Display Preferred Mode is checked, the
maximum resolution will be the EDID preferred mode. If it is
unchecked, then it will be the largest mode in the Cloned displays
mode list. Clone mode can only be exited through the Barco
Adapter Configuration page in the Barco Advanced Control Panel.
Not all options are available at all times. Please select the help tips
in the driver software for more information.
To Next Page
Loading...
