How to fix Barco G60 Projector when no image appears on screen?
If no image appears on the screen of your Barco Projector, first ensure that all cables and the AC power are correctly connected. Also, check that the pins of the connectors are not crooked or broken. Finally, verify that the “Shutter (AV Mute)” function is disabled.
What to do if the Barco Projector remote control does not work?
If the remote control for your Barco projector isn't working, ensure it's pointed within ±30° to the remote receivers on the projector and that there are no obstructions. Check the remote's batteries to make sure they are correctly inserted and replace them if necessary. Also, ensure you have set the correct IR code to the remote control.
How to fix partial or scrolling image on Barco G60 Projector?
If you're seeing a partial, scrolling, or incorrectly displayed image on your Barco Projector, try pressing “Auto” on the remote control to automatically detect the input signal. If using a PC or Notebook, set the resolution to WUXGA (1920 × 1200) or lower. For notebooks, press the appropriate keys (e.g., [Fn]+[F4]) to send the signal to the projector. If you still have trouble changing resolutions or your monitor freezes, restart all equipment, including the projector.
How to adjust image size on Barco Projector?
If your Barco projector image is too small or too large, adjust the image size using the “Zoom ?” or “Zoom ?” button on the remote control or control panel, or select “Options > Lens function > Zoom“ from the OSD menu. You can also adjust the distance between the projector and the screen or modify the aspect ratio by selecting “Screen > Aspect Ratio“ from the OSD menu.
How to fix blurry image on Barco G60 Projector?
If the image from your Barco projector is fuzzy and blurry, try adjusting the focus by pressing the “Focus ?” or “Focus ?” button on the remote control or control panel until the image is sharp and clear. Alternatively, adjust focus from the OSD menu by selecting “Options > Lens function > Focus.“ Also, ensure the projection screen is at the correct distance from the projector.
What to do if Barco G60 stops responding?
If your Barco projector stops responding to all controls, turn off the projector if possible, then unplug the power cord and wait at least 60 seconds before reconnecting the power.
How to correct keystone on Barco Projector?
To correct an image that is not an even rectangle on your Barco projector, use the keystone correction feature. Press the “Keystone H“ and “Keystone V“ buttons on the remote control, or navigate to “Screen > Geometric Correction > V. Keystone or “H. Keystone” in the OSD menu.
How to reverse image on Barco G60?
To reverse the image on your Barco projector, enable rear projection by selecting “Screen > Rear Projection > On” from the OSD menu.
To Next Page
General
