Barco G60 - Powering On the Projector; Powering Off the Projector

R5910887 /00 G6022
2.5 Connecting to video sources
Wiring diagram
1
2
3
4
5
Image 2-8
1 HDMI cable
2 VGA to RGB scart
3 VGA in cable
4 RCA component cable
5 15-pin to 3 RCA component/HDTV adapter
Notes on wiring diagram:
• The diagram shows the cables/connectors that may be used to connect to various devices.
• Due to the difference in applications for each country, the accessories required in some regions may be
different from those shown.
• This diagram is for illustrative purposes only, and does NOT indicate that these accessories are supplied
with the projector.
2.6 Ceiling mount installation
Requirements
To prevent damage to your projector, please use a Barco recommended ceiling mount. Ensure the screws
used to install the mount to the projector meet the following specifications:
• Screw type: M6 x 4
• Mounting holes (reference 1, see illustration below)
Installation