Barco G62 - Powering On the Projector; Powering Off the Projector

R5914653 /02 G6236
5.1 Powering On the projector
How to power On the projector
1. Power on the AC switch (1) and wait until the power button on the control panel is solid red.
1
Image 5–1
2. Turn on the projector by pressing the POWER button (2) on the control panel or the ON key (3) on the
remote control.
INPUTEXIT
MENU
LENS
FOCUS ENTER
ON OFF
21 3
54 6
2 3
Image 5–2
The status LED (4) will flash orange. The startup screen will display and the status LED will turn to solid
green.
4
Image 5–3
3. Turn on your source. The projector detects the source you selected and displays the image.
Note: If you connect multiple sources at the same time, press “Input” key on the control panel or
on the remote control to switch inputs.
WARNING: Do not look directly into the lens when the projector is turned on. The strong light might
cause permanent eye damage.
5.2 Powering Off the Projector
How to power Off the projector
1. Press the POWER button (2) on the control panel or the OFF key (5) on the remote control, a message
displays on the screen.
Powering On/Off the projector