Barco G62 - LED Indicator Status Chart

77R5914653 /02 G62
Image is reversed
• To reverse the image, enable rear projection by selecting “Installation > Orientation > Direction > Rear
Projection” from the OSD menu.
The projector stops responding to all controls
• If possible, turn off the projector, then unplug the power cord and wait at least 60 seconds before
reconnecting power.
If the remote control does not work
• Check if the operating angle of the remote control is pointed within ±30° (front and back) to the remote
receivers on the projector. Make sure there are any obstructions between the remote control and the
projector.
• Check the remote batteries. Make sure batteries are inserted correctly. Replace the batteries if they are
used up.
• Ensure you have set the correct IR code to the remote control. See “Remote Settings“ in the chapter
“Remote Setup”, page 60.
12.2 LED indication chart
Overview
1 2 3
Image 12–1
1 AV Mute LED
2 Status LED
3 Light LED
Explanation
Message
Light LED
Status LED AV Mute LED
Green
Orange
Red Green
Orange
Red Green
Orange
Standby State
Power on
(Warm up)
Flash-
ing
Power on & Laser
diode on
Steady Steady Steady
AV mute is off
(Image is displayed)
Steady Steady Steady
AV mute is on
(Image is black)
Steady Steady Steady
Troubleshooting