Warranty Statement
58
products;
B. The warranty described herein shall not include the following:
2.1
Any hardware or software item procured from a source other than Barco nv, MID or their official agent
or distributor and integrated by Customer or a third party into Barco nv, MID supplied equipment.
2.2
Any host configuration not explicitly supported by Barco nv, MID.
2.3
All software installed on the system, whether they are acquired from Barco nv, MID or third party. An
exception is made for software delivered by Barco nv, MID that would prove to be a cause for the mal
functioning of the hardware covered under this Agreement.
2.4
Normal wear and tear, use under circumstances exceeding specifications, such as use in dusty
environment or under excessive temperature conditions, abuse, unauthorised repair or alternation, lack
of proper configuration or maintenance, damaged or modified or removed serial number, cosmetic
refurbishment.
2.5
Repair or replacement of consumables
1
or specific parts that by definition are subject to wear and tear,
including but not limited to:
a.CRT’s, LCD panels
b.Backlights in diagnostic LCD displays, when the backlight run time
2
is beyond the Guaranteed
Backlight Lifetime
3
of that model, when used at the Factory Calibrated Luminance
4
Eg1.
• A display is used at 8 hours/day; ie. +/-2.920hours/year
• The display system is covered with a warranty period of 5 year
• The Guaranteed Backlight Lifetime of that model is 17.000hours.
• The Factory Calibrated Luminance cannot be achieved anymore after 4 year, thus
corresponding to +/-11.680hours
• Result: the backlight replacement is performed under warranty
Eg2.
• A display is used at 24 hours/day; ie. 8.760hours/year
• The display system is covered with a warranty program of 5 year
• The Guaranteed Backlight Lifetime of that model is 17.000hours.
• The Factory Calibrated Luminance cannot be achieved anymore after 2.5years, thus
corresponding to +/-21.900hours
• Result: the backlight replacement does not make part of the warranty coverage.
(1): ‘Consumable’ is a part that can be replaced by the user
(2): ‘Backlight run time’ is the total time that an image (including use of a screen saver) has
been applied to the screen; this value can be consulted via the OSD buttons (On Screen
Display).
To Next Page
Loading...
