User Manual “Streaming Client“ - V1.31 - 8. Jan. 2007
3.1 Network settings
This chapter explains how to adjust the network settings
of the Barix device.
We recommend that you set a Static IP address. With a
static (permanent) IP address the device does not have to
get a new IP address at power on or reboot.
Use SonicIP
If “Use SonicIP” is set to yes, the device will announce its
IP address over the audio output during start up.
IP Address
Enter the 4 values of the desired static IP address e.g.:
• “192.168.0.12” for an internal LAN
Attention: Make sure that you enter a free IP address.
The device will check this and will not be available until
the device using the same IP is disconnected or switched
off. The command Ping can be used to ensure that a
specific IP address is unused (i.e. No reply).
The automatic discovery functions are not executed if a
static IP address is set.
Enter 4 zeroes to enable it:
• “0.0.0.0” for automatic discovery (Discovery order:
14 Device Configuration
To Next Page
Loading...