Bartec USA TPMS PRO Series User Guide Rev5.1 Table of Contents
Page 3
Important Notices
COPYRIGHT
No part of this manual may be reproduced, stored in a retrieval system or transmitted, in any form or by any means - electronic,
mechanical, photocopying, recording, or otherwise - without prior written permission from Bartec.
DISCLAIMER
Bartec makes commercially reasonable efforts to provide accurate and complete data in connection with our tools and our
website, but the volume of data compiled and the variety of sources from which the data comes makes it impossible to warrant
full accuracy or completeness of any kind. AS A RESULT, BARTEC DOES NOT WARRANT, AND SPECIFICALLY DISCLAIMS ANY
WARRANTY, THAT THE SITE, TOOLS, AND/OR THE CONTENT CONTAINED THEREIN IS ACCURATE OR COMPLETE.
All specifications, illustrations and information contained within this manual are based on the most current information available
at the time of publication. Bartec USA reserves the right to make changes at any time without obligation to notify any person or
organization. Bartec USA will do its best to keep you the customer informed of any changes that might affect the tools
performance. Important items will be called out by using “NOTE.” Information following this indication should always be paid
attention to.
Whenever you see this symbol, the information you are about to read is vitally important and should be
committed to memory.
FCC COMPLIANCE
FCC ID: SX8T500 IC: 5736AT500
Contains FCC ID: QOQWT12 IC: 5123A-BGTWT12A
Contains FCCID: YOPGS1011MIP IC: 9154A-GS1011MIP
This device complies with Part 15 of the FCC Rules and with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Note: Changes or modifications not expressively approved by the party responsible for compliance could void the user's authority to operate the equipment.
To Next Page
Loading...
Need help?
General