Bartec USA TPMS PRO Series User Guide Rev5.1 Table of Contents
Page 26
4.0 Program Sensor
Bartec PRO Series tools offer a unique feature: the ability to program various aftermarket sensors. Select Program Sensor from
the Home menu and follow all on-screen instructions relating to sensor programming.
Program Sensor can also be accessed from the Relearn Toolkit (see Section 5.6).
4.1 Procedure
Bartec recommends programming sensors before fitting them to the wheel. Ensure there are no other sensors within a 10-foot
range during sensor programming to prevent RF interference.
To program a sensor, select the MMY of the vehicle.
Universal Sensors: Select the type of sensor being programmed. Only the listed sensors are supported for that vehicle.
NOTE:
If the sensor type selected does not require programming, the tool will prompt accordingly.
ID Option: Create ID creates a unique ID for each sensor and is used for the majority of sensor programming. Copy ID should
only be used when programming different tire sets for the same vehicle (e.g. summer/winter tires).
Wheel Position: Select the wheel position for that sensor.
Follow the on-tool prompts to complete the programming.
4.2 Contact Sensors
“Contact” or “CUB-style” aftermarket replacement sensors are fully programmable,
but require a direct connection to a programming tool via contact leads (i.e. no
wireless programming). Because of this design, these sensors can only be
programmed outside of the wheel.
All Bartec PRO Series tools support programming contact sensors using the CUB Programming Fixture accessory (see Section
10.3: Accessories and Replacement Parts).
Follow the instructions on the CUB Programming Fixture’s included Quick Start Guide and the on-tool prompts to complete
sensor programming.
To Next Page
Loading...
Need help?
General