EasyManuals Logo

Bartec Pro Series User Manual

Bartec Pro Series
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
Bartec USA TPMS PRO Series User Guide Rev5.1 Table of Contents
Page 27
5.0 Relearn
A TPMS relearn is the process in which TPMS sensor IDs are stored or written to the ECM of the vehicle. There are five categories
of TPMS relearns:
Stationary
Auto (Drive)
OBDII Connect
OBDII Assisted
Indirect (Vehicles have no sensors)
Your PRO Series tool will display the relearn process right on the screen, and will also
list the Tire Industry Association (TIA) Relearn Process Reference number for cross-
reference to the TIA TPMS Relearn Chart.
Bartec recommends performing a TPMS relearn any time a vehiclestires are
removed.
When a vehicle is selected on the PRO Series tool by MMY, the relearn procedure can
be viewed at any time by using the arrow keys to navigate to the Information icon,
pressing Enter, and then selecting View Relearn Procedure.
5.1 Stationary Relearns
Stationary Relearns use the vehicles on-board TPMS system to listen for transmissions from TPMS sensors while the vehicle is in
“Learn Mode”. This is usually achieved through a series of actions performed on the vehicle to place it into this mode. Once the
vehicle is in Learn Mode, use your PRO Series tool to activate the sensors. The vehicle will listen for the sensor IDs and assign
them to the correct wheel positions on the vehicle.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bartec Pro Series and is the answer not in the manual?

Bartec Pro Series Specifications

General IconGeneral
BrandBartec
ModelPro Series
CategoryDiagnostic Equipment
LanguageEnglish