Bartec R3 Series User Manual

Safety precautions
9
Operating Instructions Radiation sensors R3XX
2 Safety precautions
The equipment is produced in line with the regulations currently in force and
only leaves the factory following thorough safety tests to ensure that it is in
perfect condition. Please follow the instructions provided with regard to
installing and operating the equipment.
2.1 General information
 Please read the operating instructions prior to installing and starting up
the equipment. Should you have any questions or difficulties, please
contact our service staff.
 Provide your operating and maintenance staff with detailed instructions
and provide them with all the information they need.
 The equipment’s internal self-monitoring systems and fault reports do
not replace the safety facilities in the overall system into which the unit is
integrated.
 Make sure that all regulations relating to the operation of your system
are observed.
 The equipment must be installed and maintained by qualified technical
personnel.
 Make sure that the data and operating conditions specified by BARTEC
are observed.
 For the utilisation of the IR protection window ZnSe, please observe the
safety instructions under chapter 3.3.2.
2.2 Installation location
 When installing the equipment, make sure that you observe the
permissible climatic and temperature conditions in line with the technical
data.
 If exceptional conditions exist at the installation location, suitable
measures must be taken to protect the equipment (cover, cooling,
heating). Please also look at the accessories we offer with respect to
this.
 Install the equipment in a location that is not subject to vibrations.
 Do not choose a location near any equipment that generates
electromagnetic fields (transformers, motors, power lines, magnets,
semiconductor actuators, high-frequency generators and the like).
 The sensors should be installed in a separate location to protective
circuits wherever possible.
 If, due to the local circumstances, inductive consumers such as
contactors or solenoid valves are installed nearby, interference in the
contactor coil should be suppressed using an RC circuit. Usually, the
manufacturers of this equipment offer appropriate suppressor
accessories.

Bartec R3 Series Specifications

General

Brand	Bartec
Model	R3 Series
Category	Accessories
Language	English