Bartec R3 Series - Connection; R 300, R 301, R 302; Connection Via Plug

Installation
27
Operating Instructions Radiation sensors R3XX
3.4 Connection
3.4.1 R 300, R 301, R 302
The sensors can be connected either using a 4-pole plug or using a
connected cable with free ends.
3.4.1.1 Connection via plug
Note:
When connecting the sensors, make sure that the maximal permissible load
at the sensor output is not exceeded.
The combined resistance of the connected units and cables must not
exceed the maximum value shown in the diagram. This value depends on
the auxiliary power used.
At a supply voltage of 24 V d.c., the maximum permissible load is 500  .
Plug connector
3
2
4
1
External view /
connector soldering side
R 300 /301 /302



Power
1
2
Evaluator
4...20 mA
+
+
–
Shield
Example
Max. permissible load (Ω)
Auxiliary power (DC)
0 100 200 300 400 500 600 700 800
15 V
20 V
25 V
30 V