www.micro-components.com, microComponents@bartels-mikrotechnik.de
Tel: +49-231-9742-500, Fax: +49-231-9742-501
1. General
This operating manual contains all necessary instructions for the installation, commissioning, operation and
maintenance of the mp6 and mp6-pp micropump and of the controller mp-x, mp6-OEM and mp6-EVA with
the mp6 and mp6-pp.
The unit has been designed with state-of-the-art technology and in accordance with all relevant safety
regulations. However, a risk of damage to the units, other property, the operator and/or other persons
cannot be fully excluded.
Always comply with the following general instructions:
• Before working with a pump, you must be fully familiar with its operation and functions.
• Prior to operating the pump, read this operating manual and adhere to all instructions.
• Refrain from any operations that might endanger the safety of the unit.
Bartels Mikrotechnik GmbH rejects any responsibility for damages to persons or property resulting from
non-compliance with the instructions in this manual. In this case all warranties shall be void.
1.1 Declaration of conformity
Bartels Mikrotechnik GmbH is certified according to DIN EN ISO 9001:2000 and declares that the products
are compliant to the RoHS directive and the controller comply with the requirements of EMC 89/336/EEC
and CE markings have been affixed to the devices.
1.2 Description of functions
The micropumps have been developed for the transport of gases or liquids. The mp-x controller, the mp6-a
controller, mp6-OEM and mp6-EVA controller have been developed for operating one mp6 or one mp6-pp.
Bartels Mikrotechnik can assume no liability for damages resulting from the pump media. This applies
especially for hazardous fluids.
The pumps must be operated with Bartels Mikrotechnik electronics. Bartels Mikrotechnik GmbH cannot
guarantee the proper work of the units with customer specific electronics. If other controllers than the ones
from Bartels Mikrotechnik are used, Bartels Mikrotechnik disclaims any warranty.
Please make sure that only skilled personnel works with the pump control and micropump. The micropump
shall be under constant supervision at running conditions. And please note that components of the
controller and pump are operating with high-voltage. Therefore persons wearing pacemakers are
recommended to avoid the operating system.
Bartels Mikrotechnik assumes no liability for abnormal handling, improper or negligent use of the
micropump and the controller that is not conform to the specified purpose of the system. This applies
especially for micropump controllers, components and systems of other manufacturers, which have not
been certified by Bartels Mikrotechnik.
We guarantee that the micropumps comply with the actual state of scientific and technical knowledge and
due to this the operational risks are limited to a minimum.
Do not open the housing of the micropump and the controllers. In those cases Bartels Mikrotechnik can not
issue a guaranty anymore. Please keep this manual safe and give a copy to all users.
To Next Page
Loading...