Page 14 of 82 OM0408/49
Figure 1b. MS2 meter, rear panel.
Key to Figure 1b
1. Power supply connector
2. RS-232 serial interface
3. Three-way rotary switch
4. Charging light
The rear panel contains the following features:
1. Power supply connector: the power adaptor plug should be inserted here. For more
information see Internal Batteries.
2. RS-232 serial interface: an MS2 RS-232 cable can be inserted here and connected to a
computer to allow control and communication using Bartsoft or Multisus software. For more
information see Serial Interface.
3. Three-way rotary Switch: allows the user to select one of three RS-232 communication
settings options. For more information see Serial Interface.
4. Charging light: this LED will light up when power is connected and the MS2 battery is being
charged. For more information see Internal Batteries.
Connect the sensor to be used to the front panel socket of the MS2 meter with the supplied 50Ω
TNC-TNC cable, and switch on by selecting either SI or CGS units.
31 2
4
To Next Page
Loading...
