Page 7 of 82 OM0408/49
This manual describes the operation of the MS2 range of magnetic susceptibility measurement
instruments.
It should be read in conjunction with the magnetic susceptibility product brochure DS0020 and
operation manual OM1131 (Multisus for Windows), both of which are available on the MS2/MS3
product page on the Bartington Instruments at www.bartington.com/ms3.html.
Outline drawings of the MS2 meter and sensors are also available on the product page.
Following the instructions in this manual will enable the optimum operation for which your
equipment is designed. Failure to follow these instructions may invalidate your warranty.
The following symbols used within this manual call your attention to specific types of
information:
WARNING: Indicates a situation in which serious bodily injury or death could result if the
warning is ignored.
Caution: Indicates a situation in which bodily injury or damage to your instrument, or both,
could result if the caution is ignored.
Identifies items that must be disposed of safely to prevent unnecessary damage to the
environment.
Note: Provides useful supporting information on how to make better use of your purchase.
2. Safe Use
WARNING: While the MS2 meter usually runs off internal batteries, it can also be powered
by mains electricity. Ensure that the unit is properly earthed at all times. When using
the mains power supply, ensure that the mains adaptor is correct for the local AC mains
voltage (110V or 240V). Do not open the casing or have contact with any internal parts.
WARNING: In addition to the above, ensure that the mains selector on the MS2WFP sensor
is set to the local AC mains voltage (110V or 240V).
WARNING: These products are not qualified for use in explosive atmospheres or life
support systems. Consult Bartington Instruments for advice.
To Next Page
Loading...