Bartington MS2 - Figure 2. Replacing the MS2 Battery; Figure 3. Screws in the Base of the MS2 Meter

BARTINGTON INSTRUMENTS
Page 18 of 82 OM0408/49
5.6.4. Replacing the MS2 Meter Battery
Figure 2. Replacing the MS2 battery.
Key to Figure 2.
1. NiMH battery pack
2. Two-way connector
3. Earth lead to earth point in the upper enclosure
For MS2 meters purchased prior to 1st January 2006, scrape away the wax coating over the four
slotted nuts in the base of the unit and undo the nuts with a 6mm wide split screwdriver.
Figure 3. Screws in the base of the MS2 meter.
1 2
3