Page 35 of 82 OM0408/49
the sensor and, when not in use, it should be stored together with the calibration sample in
the box provided.
Caution: The sensor should be cleaned only with weak detergent and water, should this be
necessary.
Figure 11. MS2 probe handle for use with probes type MS2D and MS2F
Key to Figure 11
1. MS2 meter
2. TNC coaxial cable
3. Probe
4. Lower extension tube
5. Upper section, with handle
6. Electronics module
The MS2 probe handle is for use with the MS2D and MS2F field probes, it is not compatible with
any other sensors. The handle provides the measurement electronics for the sensors, as well as
giving extra reach to the user when taking measurements.
6
5
4
3
1
2
To Next Page
Loading...