Page 78 of 82 OM0408/49
2. Replace the tall sample platen with the short one, and secure it in position by replacing and
tightening the retaining screw.
Figure A3.1e-f. Changing the MS2B platen.
3. Refer to Appendix 4 to re-adjust the Platen height in order to centre the sample within the
aperture.
Sample adaptors are supplied with the AMSWIN-BAR package. Instructions for measurement
procedures are given in the AMSWIN-BAR CD-ROM © Morris Magnetics Inc.
To Next Page
Loading...
