22
Restore Presets
Restore all preset programs and offsets to factory settings.
Restore User Programs
Restore individual User Programs 1-12 back to factory setting. Select the User Program
to be restored and press “RESTORE”. This will clear any changes made to that user program
from factory settings. Once you press “RESTORE” this cannot be undone. The restored default
program will be loaded into the controller upon pressing “RESTORE”.
Reset TC Offsets
Reset thermocouple offsets to factory settings. Default TC Offset = 0 for all
thermocouples. To reset: Press “2-Reset TC Offsets” and press “RESTORE”.
Restore Cone Offsets
Reset cone offsets to factory settings. Default Cone Offset = 0 for all cones. To reset:
Press “3-Reset Cone Offs” and press “RESTORE”.
Restore Glass
Restore the Glass firing setting back to factory. Once “RESTORE” is pressed, any changes
made to the Glass profiles will be restored back to factory and cannot be undone.
Customization
Customization allows you to change what program menus are available and which set of custom
User profiles to be loaded into the controller either a Mix, Heat Treat, or PMC.
Ceramic Menus
Allows the user to enable or disable the ceramic programming menus. When disabled,
the Bisc and Glaze programs will be removed under “Load Program”.
Glass Menus
Allows the user to enable or disable the glass programming menus. When disabled, the
glass programs will be removed under “Load Program”.
User Library
Allows the user to change which customizable user programs are to be loaded into the
controller. Options for programs include “Mix”, “Heat Treat”, and “PMC”. For a list of the User
Libraries, see Appendix C.
Factory Configuration
Factory configuration is used by the kiln manufacturer to set kiln specific parameters for the controller
such as thermocouple type, top temperature, and board temperature. For more information, see the
technical manual online. Contact the kiln manufacturer before making any changes that might damage
the kiln.
To Next Page
Loading...
Need help?
General
