2
Introduction
This manual covers the operation of the Genesis 3140 & Genesis 1120 kiln controllers. The Genesis
is a versatile touch screen controller that regulates the temperature in your kiln so you can fire a variety
of products like ceramics, glass, jewelry, and more. The Genesis has preset ceramic programs with cone
fire programming, preset glass firing profiles, and 30 custom programs, along with Wi-Fi capabilities for
software updating, built in diagnostics, and maintenance logging among other new features.
Precautions
The controller is used to control temperature; it is not a safety device.
Do not operate the controller in temperatures above 160ᴼ
F.
Always supervise your kiln during a firing.
The controller contains electronic components which are sensitive to static electricity.
Before handling the controller dissipate any static charge you may have by touching metal or
a screw on the controller panel, the electrical box, the kiln lid, or some other grounded
object.
Always check the position of the thermocouple probe before starting a firing. The current
temperature displayed on the controller is measured at the end of the thermocouple which
must be in the firing chamber about 1” to 1-1/2”. Seal the opening around the thermocouple
with kaowool or similar material if necessary.
Always review the current program before firing to ensure the correct profile is
programmed.
Ensure the kiln and the areas around the kiln are clear of combustible material. See kiln
manufacturer’s recommendation on required clearances.
To Next Page
Loading...
Need help?
General
